Sir Newton
Member
Last Activity: Today, 03:07 AM
Joined: 08-13-2020
Location: CYQU
-
The positions are station B & D. Basically they are simple mock ups of the aileron & flap drive linkage. Dwg: 11B -
Hello everyone who reads this message of general cheerleading the project on. We have now moved on to rib placement between the spars ! This is how I...You do not have permission to view this gallery.
This gallery has 2 photos.Last edited by Sir Newton; 05-11-2021, 11:04 PM. -
It is alodine, I had a chat with our local inspector today about priming before his pre-cover inspection, He did not care one way or the other. So I will...Last edited by Sir Newton; 05-05-2021, 01:31 AM. -
We have passed a major milestone. The wing spars have been completed. If I had to guess it took in and around 300 hours to complete all 4 wing spars....Leave a comment:
-
Bcone1381, lol, Yes I am. I even bought 2 rolls of 3/4. I am just to cheap to use it.
I watching Mike Patey bending spars on his UT channel. Mike...Last edited by Sir Newton; 05-01-2021, 01:19 PM. -
This is what the RH main spar looks like up on the jig after I stuffed proper length rivets into every single hole ! before I start bucking rivets. There...Leave a comment:
-
Hello BearHawkers, Just some general cheerleading here. SO, Riveting on LH main & rear spars are complete. The spars came out straight as an arrow...You do not have permission to view this gallery.
This gallery has 4 photos.Leave a comment:
-
My 1st choice is a GMC crate engine LSA with a firewall forward PSRU swing a 4 blade MT. This combo will make 430hp with 550fbs of torque @ 3800 rpm... -
Very nice engineering. I would prefer to have a design similar to yours as a center throttle quadrant in BH5. The look is just better! -
100% I will cheerlead you on!...Leave a comment:
-
100% wisdom. -
What is the angle of the back side of the screw you are using? Dimple dies typically are 100 degs. Verses screw head angles being 82 degs or 100degs depending...Leave a comment:
-
Senor Bcone1381
The 30 min time frame I refer to in post# 43 is not from a raw rib blank. It took me 30 minutes per rib was to fabricate & anodyne...Last edited by Sir Newton; 04-22-2021, 09:53 PM. -
VNE on the BH5 is listed as 180 mph, All the other speeds will be influenced by the weight of the build & unique to individual planes.Leave a comment:
-
Your making good progress, PropMan ! -
I have something to admit, I am addicted to building BearHawks. Picked up Patrol plans. Project #2You do not have permission to view this gallery.
This gallery has 1 photos.Leave a comment:
-
This was an entertaining conversation to read. Being a professional welder with internationally recognized certifications in pressure welding. Attending...Leave a comment:
-
Greetings to my fellow builders. Just general project cheerleading here, Attached are pictures of RH main rib with all the stiffeners ready of riveting....You do not have permission to view this gallery.
This gallery has 2 photos.Leave a comment:
No activity results to display
Leave a comment: