noema
Stefan Hechenberger
Last Activity: Yesterday, 04:04 AM
Joined: 11-01-2020
Location:
-
I would use a shorter bolt in place of the one with the three washers. It's one thread too many for my taste. If I had to keep the long bolt and I was... -
With the S-shape installed horizontally, this should effectively prevent that. -
I had my wings leaning against a wall with some foam padding in between and under. My plan was to transfer them to a table when I run out of tasks that...Leave a comment:
-
I will probably connect mine directly with a strain relief S-curve. Has plenty of flexibility. Don't see a problem forgoing a flexible hose. Open to feedback....Last edited by noema; 02-10-2025, 05:10 PM.Leave a comment:
-
I considered doing something similar but then opted to go with a Li-Fe backup battery (IBBS via ACS). I wasn't comfortable with the failure modes of Li-Ion...Last edited by noema; 02-10-2025, 05:32 PM.Leave a comment:
-
Mostly agree with Battson. Doing layups on on-time foam plugs is a good middle ground. I have built quite a few parts for my Bearhawk this way, including...Leave a comment:
-
Did you get some quotes from any of the prototyping services. If not, might be worth checking out.
Some I know, but there are more:
...Leave a comment:
No activity results to display
Leave a comment: