pnh2atl
Junior Member
"No kit, yet!"
Last Activity: Today, 07:04 AM
Joined: 10-04-2022
Location: KCNI
-
The 5 also has a datum line. I’ve got the pitch level using that. The -2 degree incidence for the 5. The wider base is a great idea. I’ll press on... -
I used shims under a main gear tire to get it wings level essentially. I used the tube that runs between the forward main gear attach points to measure...Leave a comment:
-
Where to measure plumb
I’ve leveled the fuselage at the wheels. When I put the level on the vertical stabilizer it is .9 degrees off. I’d like to check the angle of incidence...You do not have permission to view this gallery.
This gallery has 2 photos. -
They are in the AS order coming today. All great advice....Leave a comment:
-
That’s great! Thanks it will help a lot....Leave a comment:
-
Elevator bearing
How do the two elevators connect? Is there a pin that goes through the fuselage and into the bearings? The “Elevator Bearing Kit” has 4 bearings.... -
I’m just putting my horizontal stab on now. My mount tube was labeled left, up and front and right, up and front. Only two could ce correct at any time....Leave a comment:
-
Leave a comment:
-
That’s good stuff. I’ve got an Aircraft Spruce order started. I will incorporate this into it!...Leave a comment:
-
Thanks! jfoz that’s great thanks. Just knowing where to look is half the battle....Leave a comment:
-
What bolt where
Just started a QB 5 kit. I know Virgil is working on improved directions which will be done just after I finish with my luck.
1. Is there... -
Started Kit 47 today
Nothing exciting but the BH5 QB forum has been sloooow. I assembled both the struts. Pretty straightforward. Tomorrow we will start the brakes. Hopefully...You do not have permission to view this gallery.
This gallery has 1 photos.
No activity results to display
Leave a comment: