stinger
LSA Builder
Last Activity: Today, 08:08 AM
Joined: 11-28-2013
Location: North Florida FL10 - Flying little river Jax Sectional
-
Good job, of course I did not originally see the area of concern I would have followed your lead . Stinger -
Good Morning, I agree , I felt it was a very dangerous . The picture looks like I spread a lot but it is actually 1/8 also. Stinger -
Bearhawk LSA Annual Inspection
Annual inspection 135 hrs. Upon inspection I found rod end bearing GMM-3m-680 jam nut loose and rod end rotating inside push pull rod threaded area.... -
Dave, just a observation but should you be building the cowling with out the exhaust ? Fiberglass is easy to repair so don't worry about the crunching... -
Jim, So sorry to hear about your illness, you have been a very good contributor to the forum, your knowledge continues to blow me away. Even though you... -
Chewie, I think you are on the right track . The cord line on the Mylar is correct. Example: on the LSA I measured up from the bottom of each spar to... -
CAUTION : I spoke of this in the past, not so much as how to build a jig but the spar alignment. If you are building the RIBLET wing align the spars as...Leave a comment:
-
Rob, when building my LSA I also used hinges that pulled or sucked the cowling down . I purchased my hinges from Spruce about 10 bucks each. February...
No activity results to display
Leave a comment: