Tail materials T25

[Bradrock]

Can anyone tell me what sizes of .032 steel strips they ordered for the tail please? Given that the opposite ends of any given piece of T25 may fit onto different sizes of tubing, I'm not sure how to go about it. Obviously this is new territory to me, so any advice appreciated.

[old pete]

Bradock
I went and built mine from .032 sheet. all I will say is that if I do this over again I will buy them all ready done from mark. well worth the $$. just in time savings and Hassel alone.
I had a hyd shear I was using and a decent brake.and it was still a little bit of a challenge to get them right.
just my 2 cents

[Bradrock]

Thanks Pete. Still in time to order from Mark. Thanks for the response.