marcusofcotton
4 place scratch build
Last Activity: Today, 05:46 AM
Joined: 09-23-2013
Location: NE Minnesota
-
Welcome Derek! Advice at this point, with two little ones at home? Reconsider a four place. : o ) -
Mark, good plan except skip the shims, just center the rivets and don't go to close to the nose skin. No different than what happens at the ends where...Leave a comment:
-
Actually I fit six rivets rivets at each rib with proper spacing (three on each side)....Leave a comment:
-
I've been one of the ground "runners" at the New Holstein Supercub get together in recent years. July 2018 results showed of 17 competitors,...Leave a comment:
-
Airplane building surviving at -60F? It does slow it even further anyway. The official NWS station in Cotton is two miles east of me, we've been listed...Leave a comment:
-
The lighter the nose is, the less you you can put in the rear baggage due to aft CG. Certainly can, even likely to, become a limiting factor, certainly...Last edited by marcusofcotton; 01-31-2019, 06:25 AM.Leave a comment:
-
Until seeing the recent barnstormers ad, I figured I may have the slowest Bearhawk out there, sadly already competing well for that title in the build...Leave a comment:
-
I had no troubles on the four place, can't say if the Patrol is the same....Leave a comment:
-
I also left installing the trailing edges until fitting to the wing. Another good tip, I don't remember from whom, was to hold off on riveting (but do...Leave a comment:
No activity results to display
Leave a comment: