Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I used this product on the face of wall studs when I was building a theater room 15 or 20 years ago. I wonder about marking the tubing locations on the...
- Likes 1
-
The 5 kit has a nice setup, with just a single fitting in between the fuel selector and gascolator. It should make installation much easier, but I have...
Leave a comment:
-
-
Floorboard Doublers?
I have been working on the floorboards. They required very little adjustments to get them to fit well.
The manual mentions creating doublers...
-
Broken #40 Countersink Cutter
Call me crazy, but I decided to stick with the kit and do rivnuts for the floor. While countersinking some of the holes, I broke off the nipple end of...
-
Thanks for the input. I am placing the order today, so it was good timing.
-
I just wanted to add a couple of thoughts. Don't wait until the end of a build to start flying. From my time as a CFI, I found that the students who...
- Likes 1
Leave a comment:
-
-
Sort of in the same boat. I have 23000+ hours, but zero tailwheel time. I've only landed on anything other than a hard surface runway twice in my life,...
- Likes 1
Leave a comment:
-
I'm definitely going to keep that as an option, but the kit contains the hardware for nutplates on all of those. It's going to be a lot more work.
-
No pictures because it's nothing exciting, but I drilled out all of the floor and rear bulkhead tabs to 3/32". Lot's more drilling left on those...
Leave a comment:
-
Thanks, I'll do that.
-
Rivnut corrosion?
I have been researching rivnut installation before I do any, and have a question I can't find the answer to.
Is galvanic corrosion a concern...
- Likes 1
No activity results to display
Show More
Leave a comment: