Tweet
Can someone give me some ideas how to match drill this torque tube support bracket to rear spar? Drill obviously doesnt fit beneath torque tube.
Thanks,
Dan
Thanks,
Dan
-
You do not have permission to view this gallery.
This gallery has 1 photos. -
Last edited by Juan C. Casabuono; 11-21-2016, 06:39 PM. -
Very good!...thank you. I watch these when EAA e-newsletter comes out then I forget about them when I need them! Sheesh!
I believe there was a recent article in Kitplanes about this as well........
DanComment
-
-
I can't see the video on mobile but there are a few ways to do it. One of my favorites is a transfer punch that is matched to the hole ID and punches a perfectly centered divot that you can drill after removing the piece. That sort of presents the same problem though-- clearance to hit the punch, though just making a mark would be good enough.
The other is an angle adapter for your drill motor. You can get them fairly inexpensively on McMaster-Carr.
Edit: Now that I watched that EAA I video I understand the original problem better, so disregard my suggestion
Last edited by Zzz; 11-28-2016, 04:26 PM.Comment
Comment