Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
I also used to use the lightbulb heater method, but got frustrated with the short life and fragility of the bulbs. Several times i arrived at the hangar...Last edited by arborite; 01-22-2025, 12:19 PM.
- Likes 2
-
Low(er) cost nutplates
I went shopping for #6 nutplates today. the usual sources were pricey, especially for the countersunk ones. I found a much better price for the countersunk...
- Likes 6
-
very nice. did you form it in place? i was brainstorming ways to shrink, but since everything is predrilled, i didn’t want to mess up that align...
Leave a comment:
-
thanks for that link. i should have researched more. my tunnel holds the extension up about 1/4”. I’m considering how to reduce that a. it and...
Leave a comment:
-
boot cowl tunnel overlap
Fitting the boot cowl pieces that were pre drilled from the factory now. fit is really good but i’m not clear on how to overlap the steel tunnel piece...
- Likes 1
-
the Project Farm youtuber has done some good reviews on torque wrenches. some cheap ones worked as well as big money ones.
the key is...
- Likes 1
Leave a comment:
-
Agree on this direction. I have seen similar blockage issues on fine mesh filtration systems from surfactants in cleaning products. are you using the...
Leave a comment:
No activity results to display
Show More
Leave a comment: