Untainted123
Member
Last Activity: Today, 12:36 AM
Joined: 03-17-2024
Location: T67
-
In TX this year, that hasn't been a problem, daily in the 60-70's and sunshine. One of these days it might actually get cold, but not today
-
Savvy Article here talks about lead oxy-bromides not being scavenged properly below ~350°, leading to stuck valves. I am not sure where that comes from... -
My handle does have the doubler on it, so all good there. I will look at the angles again, and probably stick with the 2024 then. -
I know quite a few people run their SuperCubs with a pet-cock valve in the oil cooler line and cable running to the cockpit, so that they can manually...Leave a comment:
-
I don't know if NZ has or will have the equivalent of MOSAIC 2.0, but if so, I would skip the LSA and go for the Patrol if those are the options. In the...Leave a comment:
-
Perfect, I am going to go with that then.
...Leave a comment:
-
Continuing this thread because I couldn’t find a better one; I have had a lot of trouble with not being able to find the notch on any flap setting beyond...Leave a comment:
-
I need the dwg of the 4-place panel as a starting place. I have been using Front Panel Designer (free, not aviation specific) with some success, but it... -
Why stp instead of dwg? Does sendcutsend do more than just “flat” cutouts (besides offering bend service)? -
Does anyone have the panel blank .DXF file for the 4-place? I am not sure if it's the same panel as for the Model 5, and I can't seem to find anywhere...Leave a comment:
No activity results to display
Leave a comment: