Recent content by stinger

  1. stinger

    Rudder Pedal/Brakes ergonomics

    Rod, I had the same problem, I am 5ft. 6inch. I lowered the pedals pivot point under the floor frame and that did it for me . My grandson is 6ft and he has no problems . Stinger
  2. stinger

    Rivets

    these are the fuel tanks i built for my Bearhawk LSA. Yes they are made of 50/52 as the instructions call for. However, I secured the tanks with Pro Seal and fuel tank blind rivets. The bungs I purchased from Aircraft Spruce I also installed them with a sealant and standard aircraft rivets.I had...
  3. stinger

    Patrol tandem rear pedals

    Yes, this picture shows a out side view.
  4. stinger

    Patrol tandem rear pedals

    Stan, I scratched built an LSA and installed heel brakes as I wanted to teach my grandson to fly. Due to the limited space and entry the heel is all that would work for me, they are quite good . Stinger
  5. stinger

    Aero Classic 27.5” tires on LSA

    I went from 6x6 to 8x21 rib tires on Grove 6 inch wheels lost 5 mph on top end. My tires have been on for three years . I run 18-20 PSI Stinger
  6. stinger

    Patrol back seat heat

    Pbruce, Here is a picture of my back seat heater outlet , front is the same . scat tube running under floor
  7. stinger

    Baggage Pod LSA

    Retro Fit Baggage Pod 11.2lb no loss of cruise speed . Stinger
  8. stinger

    Patrol pilot window frame overlap detail

    my window frame sits behind and note the slight outward bend in windscreen securing panel this defects the wind . Stinger
  9. stinger

    Rudder pedal placement

    Dave, I suggest you look at Van's aircraft . I built a RV8 of which I installed moveable peddles. Van's sold these as an option and they worked GREAT. If I wanted to I could slide the assembly forward or aft, take a look at them. Stinger
  10. stinger

    Tripple tree. SC

    I plan to be at Triple Tree with LiL Bear. Stinger
  11. stinger

    LSA fuel tank dimensions

    Scratch built fuel tanks. In that you wish to build your own tanks I take it that you are scratch building your aircraft. Build the tanks to fit the area you have created. Stinger
  12. stinger

    Fuel cap lost

    Different strokes I bought fuel caps and flanges from Van's same as I had on my RV8. I vented by way of tubing out with three loops in wing then out under wing . Flanges are inverted.and cap installed. It works for me . No lost caps. Stinger LSA 300 hrs
  13. stinger

    Fiberglass strut cuff install

    Keeping it slick! Stinger
  14. stinger

    VS Covering Issue

    Mark,by all means once you have both sides covered and progressively bring each side up to full temp keeping tension the same. I did not stitch the bottom rib however I did put a tape there to protect. Stinger
  15. stinger

    Back in the Game

    rodsmith , Yes the plans for the LSA trailing edge are as previously stated, however I did not have access to a large brake so I used the trailing edge material as you mentioned. Stinger
Back
Top