Elevator bellcrank bearing size

[U2fletch]

Cleaned up the paint from the inside of the bellcrank, then measured the overall width of the bellcrank, 35mm. The bearings are 5mm width, so needed a bushing 25mm in between which was solved with quick stop at the lathe. Before pressing in the bearings I measured them. Not even close. OD of the bearings are 5/8”, or 0.625”. The ID of the bellcrank is 0.614. Something is not right. I checked the parts bin for any other bearing that might be close, but came up empty.

Am hesitant to ream it out before checking as it does not seem like there will be a lot of metal left on the tube.

[Ryan Koeneke]

I used a Dremel with a sanding tube to clear the paint out and then carefully kept going around and around to ensure a good fit. I think others have done the same.

[U2fletch]

That’s reassuring. I just went back and looked at the wall thickness and it should be fine. I do have a 5/8” reamer which will work nicely.

[Steve W]

I did a couple of wings for a 5 place a few months ago. I just pressed the bearings in the bellcrank without any extra effort. Felt like a good pressed fit. Was there a run of parts that were an odd fit?

[U2fletch]

This was the elevator bellcrank. I have not opened up the wing kit yet, so I expect they are slightly different.

[Steve W]

My bad! Should have read it a little closer