Fuel injection

Not a 540. But a 360. I hope others chime in about the 540. But I'll say on the 360....it was a bolt on job done by my engine builder (Bob). The bolt pattern is identical for the Bendix FI & Carburator. An engine driven fuel pump needs an accesory case to accomodate it. I've heard of some who use dual electric fuel pumps but seems uncommon.

I think the process would be remove and replace the Carb with the Servo, Install an engine driven fuel pump (~28 psi pump....carb pump is less like ~5 psi) Install the flow divider and injectors into the cylinders. Install injector lines. Install three other fuel lines. Install an electric fuel pump below your floor boards in the fuselage after the gascolator.

I encourage folks to continue to give information on the 540 and to call Airflow Performance. Don or Kyle are two I've talked to. AFP has both Bendix units they overhaul and manufacture there own new units that operate on the same principal. This conversion is the foundation of there business. I


I'm guessing north of $5000 for a new system, less for an overhauled Bendix kit.

The home page of AFP
https://airflowperformance.com/

I found their installation manual Under Manuals
 
Has anyone converted their carbureted 540 engine to fuel injected? Curious about the process and cost…
I put an Airflow performance FM250 system on my 540. Price was $3000 but that was 2010 dollars so probably a meaningless number now. As far as the process, it was straightforward. AFP provides a very detailed installation/operation manual. I decided I wanted horizontal induction for a sleeker cowl and hopefully some ram air effect. That involved some nose bowl fiberglass work to accomplish. I highly recommend fuel injection, makes running lean of peak easy. Following the recommended procedure for hot starts in the Lycoming engine manual, I have never had a problem with them. I would do some research into what options are available today.
 
My 540 was converted by Bob - he did the fuel lines, injectors, engine driven pump. I added the fuel servo when it arrived. The cost was absorbed into the engine rebuild so unfortunately that's not much help.
 
Went with full SDS EFI system. Very well done system. No issues at all. I was able to recoup some of the cost by selling off the parts from the IO-580 that were eliminated or replaced. Dual Bendix mags, fuel spider, fuel pump, Avstar fuel servo were all replaced by SDS parts. Net cost probably less than $5k. It's a full return system so did need to get a full duplex fuel selector and some extra plumbing to get fuel back into the mains.
 
Hopefully you have "injected" cylinders. Ports on the upper side of the cylinder for FI. They can be added later. I had to do it on 2 cylinders.

BTW I love the idea of 2 electric pumps. They are 120 dollars each and this would might make hot starts less of an issue.
 
Hopefully you have "injected" cylinders. Ports on the upper side of the cylinder for FI. They can be added later. I had to do it on 2 cylinders.

BTW I love the idea of 2 electric pumps. They are 120 dollars each and this would might make hot starts less of an issue.
Yes, the engine had the original fuel spider with lines to each cylinder. Easy to swap out to the electronic fuel injectors.
 
Back
Top