Wing Hardware

[DesertBearhawk]

Guys, trying to figure out the required hardware for the wing, specifically the bolts for the wing strut straps, flap and aileron mounts, and the pulleys. I was able to find little information on the plans, not saying its not there but Im not seeing it. I know the pulleys themselves are MS20220-2 and they use a 5/16 bolt. So, how do I determine what bolt(s) are required? I can figure length and dia, its the type of bolt im not sure about. Do I use a high shear type bolt for the pulleys, the wing strut steel?

Kinda lost here, what can you guys tell me?

[nuggets]

http://www.bearhawkin.com/FAQ-Technical%20tips.html#How_to_Notch_Tubing

scroll down the page dave there is a list of bolts and hardware

[Mark Goldberg]

Dave, all normal AN bolts. Nothing more exotic needed. Mark

[marcusofcotton]

... its the type of bolt im not sure about. Do I use a high shear type bolt for the pulleys, the wing strut steel?

Kinda lost here, what can you guys tell me?

Dave, use AN hardware everywhere as a general rule - review 43-13b as well. Possible exceptions may be NAS bolts for mounting upper end of oleo struts, never been a Bearhawk problem here but the Maule guys have found the need and it is very similar. Buy prop bolts when it's time for mounting the prop.

Mark J

[mswain]

Dave,

I am assembling my wings now....I just ended up taking an educated guess and bought a few sizes, longer and shorter for each item. Not very efficient but the hardware isn't too expensive in the grand scheme and I assume I'll need it sooner or later. There is enough variation in scratch building that I would be skeptical of any list that did exist. AN hardware is all that is specified in the plans.

I am using MS24566-4B pulleys in the wing.

Mike