Male shank version of AN665 clevis fork

[Zzz]

I've found these on McMaster-Carr but there's no material data or bolt grade shown. I need it in 5/16-24 with 1/4" eye hole.

Is there an AN number? Can't find anything at Spruce.

Thanks.

[whee]

AN161 but I'm not seeing a 5/16 with a 1/4 eye. You might have to make a bushing.

[JimParker256]

Wicks has exactly what you asked for: http://aircraftproducts.wicksaircraf...=prod&filter=0

[Zzz]

AN161 but I'm not seeing a 5/16 with a 1/4 eye. You might have to make a bushing.

Those are made specifically for turnbuckles. Notice how much unthreaded shank they have in comparison to the McMaster part I linked. My usage is more akin to a rod end bearing at the end of a pushrod.

[whee]

Oh, I see. I don't know man.

[JimParker256]

How are you planning to use it? Maybe the "collective" can suggest an alternative solution...

[Zzz]

How are you planning to use it? Maybe the "collective" can suggest an alternative solution...

It's to be used as an adjustable clevis that connects to an AN eyebolt. What I need is exactly what I linked above. Weird that they seem so scarce in aviation.

[marcusofcotton]

I've found these on McMaster-Carr but there's no material data or bolt grade shown. I need it in 5/16-24 with 1/4" eye hole.

Is there an AN number? Can't find anything at Spruce.

Thanks.

PMC-5-4 in Chrome Moly at:

http://www.midwestcontrol.com/series.php?id=124

In my Univair AN hardware chart, I don't see a picture of it.

[Zzz]

Thanks Mark. Strange that there's no AN part though.