Nev
Quick-build 4-place B #25
Last Activity: Today, 03:41 PM
Joined: 06-11-2018
Location: Christchurch, New Zealand.
-
Colby, I can add a couple of considerations now after 600 hours of operation. The Vans RV inlet works well. I've never removed it by itself, I just remove... -
On my build I made the interior cockpit floor panels and the centre tunnel fully removable. In practice, most servicing is done simply by lifting the...Leave a comment:
-
This is where we're currently at, having welded over the crack, and then added a doubler several mm up the pipe.
I think it's probably crucial to...Leave a comment:
-
Thanks Jono – all very interesting.
Last time it cracked it actually separated into two pieces, which made it easy to clean and prep properly...Leave a comment:
-
Good ideas, I'll run them past him. Thanks Jared. -
That looks like a very good way to support it. -
On the side with the issue I have removed the outer casing and no longer use it to provide heat. (I discussed it with Clint at the time). So the inner...Leave a comment:
-
Advice sought - exhaust cracking
Hi guys,
I need some advice. My left exhaust pipe has cracked in the exact same place 3x now which has got me scratching my head. The first...Last edited by Nev; 02-08-2026, 04:04 AM. -
Congrats Propman!...Leave a comment:
-
Thats a very nice panel ! -
They're the 10" ones.Leave a comment:
-
Thanks Brooks. That's under the Bearhawk Blog Maintenance notes here. No other areas for Loctite red that come to mind but if I think of any I'll definitely...Leave a comment:
-
Just to add a note - a few of us have added Loctite red to the aft stinger near the AN4 bolts on Bob's advice. That area has a high torsional load when...Leave a comment:
-
A second thumbs up for Dynon. I have dual HDX displays. The install was seamless with factory made harnesses, and the support from Dynon is excellent....Leave a comment:
No activity results to display
Leave a comment: