DBeaulieu
Patrol Q/B Kit #79
Last Activity: Today, 12:20 PM
Joined: 10-11-2021
Location:
-
Service Alert posted on the Bearhawk company website under the resource tab on this topic -
TJ_Slice Good question, I just tensioned them a few revolutions past uniformly max finger tight for now. Maybe someone can chime in before I do the... -
Fuel tank strap...the downside of working solo (most times)
While working with fuel tanks yesterday I noticed that one of my fuel tank straps was not bolted in at an attach point. Evidently it has been this way...Last edited by DBeaulieu; 06-12-2025, 01:09 PM. -
While pondering fuel tank cover issue, decided to go ahead and make cutouts for the wing lights. Have Flyled Taildragger Max lights for each wing. Also...Last edited by DBeaulieu; 06-11-2025, 07:31 AM.Leave a comment:
-
Bcone1381 Thanks for considering the issue Brooks.
I was in the hangar this morning with a couple of very experienced A&P/IA types with...Leave a comment:
-
Agree that is an absolutely great way to do it! -
Thank you all very much for the ideas and support. Once I have some Aluminum material to work with I have some methods to go forward with. Going up to...Leave a comment:
-
Steve W Steve, I do not plan on countersinking or dimpling for the cover. Pan head screws only. Bob was okay with that as long as I used aircraft grade... -
@Bcone That was my first thought when I realized/accepted that I may have to make a new cover. -
Dpearson "I updrilled #40 to #27 through the cover and wing structure in one pass, with the cover clecoed + screwed in place. Then removed the cover... -
Fuel tank cover issue - Factory Q/B kit
Okay...trying to get my wings ready for paint. Getting some of the last little steps done. The fuel tank bay was final drilled for nutplates holding... -
Bruce, nicely done! -
Getting wing interior work done. Pitot tube stuff, wiring, etc. Got a July date with the paint shop to get the wing paint on, so I need to get the wings...Leave a comment:
-
Appreciate all the thread replies. Going to the hangar to work today and guess I'll drill a few holes
Leave a comment:
-
Lubrication hole for flap torque tube
This is for the bearing (tube) supporting the outboard end of the torque tube. Drill for lubrication or not? Can't recall seeing it drilled in the plans....
No activity results to display
Leave a comment: