I put an Airflow performance FM250 system on my 540. Price was $3000 but that was 2010 dollars so probably a meaningless number now. As far as the process, it was straightforward. AFP provides a very detailed installation/operation manual. I decided I wanted horizontal induction for a sleeker cowl and hopefully some ram air effect. That involved some nose bowl fiberglass work to accomplish. I highly recommend fuel injection, makes running lean of peak easy. Following the recommended procedure for hot starts in the Lycoming engine manual, I have never had a problem with them. I would do some research into what options are available today.Has anyone converted their carbureted 540 engine to fuel injected? Curious about the process and cost…
Yes, the engine had the original fuel spider with lines to each cylinder. Easy to swap out to the electronic fuel injectors.Hopefully you have "injected" cylinders. Ports on the upper side of the cylinder for FI. They can be added later. I had to do it on 2 cylinders.
BTW I love the idea of 2 electric pumps. They are 120 dollars each and this would might make hot starts less of an issue.
I am actually considering the upgrade for my O-360 for fuel injection I'd be interested in a few more details on that as well as the realized benfits of the theoretical additional 20HP? ThanksNot a 540. But a 360. I hope others chime in about the 540. But I'll say on the 360....it was a bolt on job done by my engine builder (Bob). The bolt pattern is identical for the Bendix FI & Carburator. An engine driven fuel pump needs an accesory case to accomodate it. I've heard of some who use dual electric fuel pumps but seems uncommon.
I think the process would be remove and replace the Carb with the Servo, Install an engine driven fuel pump (~28 psi pump....carb pump is less like ~5 psi) Install the flow divider and injectors into the cylinders. Install injector lines. Install three other fuel lines. Install an electric fuel pump below your floor boards in the fuselage after the gascolator.
I encourage folks to continue to give information on the 540 and to call Airflow Performance. Don or Kyle are two I've talked to. AFP has both Bendix units they overhaul and manufacture there own new units that operate on the same principal. This conversion is the foundation of there business. I
I'm guessing north of $5000 for a new system, less for an overhauled Bendix kit.
The home page of AFP
https://airflowperformance.com/
I found their installation manual Under Manuals
The 20HP gain......An O-360-A1a engine has a different cylinder than the IO-360-A1a. All Carburated Lycoming 360 cu in engines use a parallel valve cylinder that is an older less powerful design than the Angle Valve cylinders found on an IO-360-A1a engine. The Angle Valve Cylinders are heavier.I am actually considering the upgrade for my O-360 for fuel injection I'd be interested in a few more details on that as well as the realized benfits of the theoretical additional 20HP? Thanks


I do have the Bob Barrow O360 with the Angle valves so I believe I have the right configuration from that standpoit?The 20HP gain......An O-360-A1a engine has a different cylinder than the IO-360-A1a. All Carburated Lycoming 360 cu in engines use a parallel valve cylinder that is an older less powerful design than the Angle Valve cylinders found on an IO-360-A1a engine. The Angle Valve Cylinders are heavier.
Like svyolo said, the fuel injection does not add any horse power. The IO-360-B1a engine is a 180 horse with the same parallel valve cylinders as the O-360. So if you swap out the carb for the FI its pretty similar to that. The first Piper arrows had this engine. So did the Beech Travelair.
View attachment 102417View attachment 102418